Hyundai Ioniq (AE): Warning and Indicator Lights / Turn Signal, High Beam, Light ON Indicator Lights

Turn Signal Indicator Light

Hyundai Ioniq. Turn Signal, High Beam, Light ON Indicator Lights

This indicator light blinks:

• When you operate the turn signal indicator light.

If any of the following occurs, there may be a malfunction with the turn signal system.

- The turn signal indicator light illuminates but does not blink
- The turn signal indicator light blinks rapidly
- The turn signal indicator light does not illuminate at all

If either of these conditions occur, have your vehicle inspected by an authorized HYUNDAI dealer.

High Beam Indicator Light

Hyundai Ioniq. Turn Signal, High Beam, Light ON Indicator Lights

This indicator light illuminates:

  • When the headlamps are on and in the high beam position.
  • When the turn signal lever is pulled into the Flash-to-Pass position.

Light ON Indicator Light

Hyundai Ioniq. Turn Signal, High Beam, Light ON Indicator Lights

This indicator light illuminates:

• When the tail lights or headlamps are on.

    This indicator light illuminates for up to 30 seconds: • When the vehicle detects the smart key in the vehicle with the Engine Start/Stop button in the ACC or ON position.

    High Beam Assist (HBA) indicator light This indicator light illuminates : When the high-beam is on with the light switch in the AUTO light position.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Mode Control Actuator. Description and operation

    DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Front View Camera Unit. Repair procedures

    Removal1.Disconnect the negative (-) battery terminal.2.Remove the front view camera cover (A).3.Disconnect the front view camera connector (A).4.Remove the front view camera after disengaging the mounting bracket (A).Installation1.Align front view camera with windshield bracket using forward edge point (A).

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0111