Hyundai Ioniq (AE): Input shaft speed sensor 2 / Components and components location
| Components |
| 1. Input shaft speed sensor (Odd) | 2. Input shaft speed sensor (Even) |
Specification Item Specification TypeHall effect sensorOperation condition (°C)°F-40 to 257 °F (-40 to 125 °C )Output signal (mA)High: 11.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: PTC Heater. Repair procedures
InspectionOperating Logic Test (Manual only)Inspect the PTC operation by confirmation logic as follows.1.Entering(1)Set the Floor mode and maximum heating position.(2)Turn off the blower switch.(3)Press the intake (recirculation) button 5 times or more.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Mode Control Actuator. Repair procedures
Inspection1.Turn the ignition switch OFF.2.Disconnect the mode control actuator connector.3.Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.Verify that the mode control actuator operates to the vent mode when connected in reverse.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Engine Clutch System
- Checking the Coolant Level
- Transmission Gear Oil. Repair procedures
- New on site
- Most important about car
