Hyundai Ioniq: Inhibitor Switch / Description and operation

Hyundai Ioniq (AE) 2017-2025 Service Manual / DCT(Dual Clutch Transmission) System / Dual Clutch Transmission Control System / Inhibitor Switch / Description and operation

Description

•	Components location : DCT (Dual Clutch Transmission)

•

Function

- The inhibitor switch mounted on the upper of transaxle and connected with shifter lever.

- The inhibitor switch has four points of contact and it makes the signals(S1, S2, S3, S4).

- The inhibitor switch signals delivered at the TCM according to control of the shift lever positions(P, R, N, D) and it is used to control of the gear setting.

Components and components location

C..

Specifications

S..

Other information:

Hyundai Ioniq (AE) 2017-2025 Service Manual: HCU (Hybrid Control Unit). Schematic diagrams

HCU Terminal and Input / Output SignalTerminal FunctionConnector [C133-S] Pin No Description Connected to 1HCU GroundChassis ground2HCU GroundChassis ground3HCU GroundChassis ground4Battery power (B+)Battery5Battery power (B+)Battery6Battery power (B+)Battery7-　8-　9-　10-　11-　12-　13-　14-　15Brake Switch 2 signal inputBrake Switch (NC, IG1)16Brake Switch 1 signal inputBrake Switch (NO, B+)17-　18-　19-　20-　21-　22-　23-　24-　25-　26-　27-　28-　29-　30-　31-32-33-34-　35-　36-　37-　38Start signal inputSmart Key Unit39-　40-　41-　42-　43-　44-　45-　46-　47-　48-　49-　50-　51-　52-　53-　54-　55-　56-　57-　58-　59-　60-　61-　62-　63-　64-　65-　66-　67-　68-　69-　70-　71-　72-　73IGN signal inputSmart Key Unit74-　75-　76-　77-　78Powertrain CAN [High] signal inputOther control modules79Powertrain CAN [Low] signal inputOther control modules80-　81Hybrid CAN [High] signal inputOther control modules82Hybrid CAN [Low] signal inputOther control modules83-　84-　85-　86-　87-　88-　89-　90-　91-　92-　93-　94-　Input/Output signalConnector [C133-S] Pin no Description Condition Type Level 1HCU GroundAlwaysDC VoltageMax...

Hyundai Ioniq (AE) 2017-2025 Service Manual: Repair procedures

Inspection1.Turn the ignition switch OFF and disconnect the battery negative (-) cable.2.Disconnect the fuel pressure regulator valve connector.3.Measure resistance between the fuel pressure regulator valve terminals 1 and 2.4.Check that the resistance is within the specification...