| SCHEMATIC DIAGRAM |

Removal You must make sure turn RED LED ON if you do any of the following.– Replace the eCall unit.– Replace the Back-up Battery (BUB).
Removal1.Disconnect the negative (-) battery terminal.2.separate the overhead console (A) from the roof trim after loosening the mounting screws.3.Remove the overhead console (A) after disconnecting the connector (A)Installation1.
C
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper