| Components |

| 1. Head lamp (Low) 2. Head lamp (High) 3. Turn signal lamp | 4. Dust cap 5. Position lamp |
Component Location1. Head lamp (Low)2. Head lamp (High)3. Position lamp4. Turn signal lamp5. Daytime Running Light (DRL)6.Turn signal lamp (Door mirror)7.
Head Lamp Aiming Instructions[Mechanical Aiming]The head lamps should be aimed with the proper beam-setting equipment, and in accordance with the equipment manufacturer's instructions.
Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.
Inspection1.Turn the ignition switch OFF.2.Disconnect the intake actuator connector.3.Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.Verify that the intake actuator operates to the recirculation position when connected in reverse.