| Replacement |
|
| 1. | Remove the rear seat back cover. (Refer to Rear Seat - "Rear Seat Back Cover") |
| 2. | After loosening the mounting bolts, remove the rear center seat belt retractor (A).
|
| 3. | To install, reverse the removal procedure.
|
Component Location 1. Rear center seat belt retractor
Component Location 1. Rear seat belt buckle [RH]2. Rear seat belt buckle [LH]3. Rear center seat belt buckle
Inspection1.Turn the ignition switch OFF.2.Disconnect the mode control actuator connector.3.Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.Verify that the mode control actuator operates to the vent mode when connected in reverse.
Inspection1.Turn the ignition switch OFF. 2.Disconnect the auto defogging connector. 3.Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.