Hyundai Ioniq: Engine Mechanical System / Special service tools
Hyundai Ioniq (AE) 2017-2025 Service Manual / Engine Mechanical System / Special service tools
| Special Service Tools |
|
Tool (Number and name)
|
Illustration
|
Use
|
| Crankshaft damper pulley adapter (09231-2M100) Crankshaft damper pulley adapter holder (09231-2J210) |
| Removal and installation of crankshaft damper pully bolt. A : 09231-2M100 B : 09231-2J210 |
| Torque angle adapter (09221-4A000) |
| Installation of bolts & nuts needing an angular method |
| Valve stem seal installer (09222-G2100) |
| Installation of the valve stem seal |
| Valve spring compressor & holder (09222-3K000) (09222-3K100) |
| Removal and installation of the intake or exhaust valves A : 09222-3K000 B : 09222-3K100 (holder) |
| Crankshaft front oil seal installer (09231-G2100) (09231-H1100) |
| Installation of the crankshaft front oil seal A : 09231-G2100 B : 09231-H1100 (Handle) |
| Valve stem seal remover (09222-29000) |
| Removal of the valve stem seal |
| Crankshaft rear oil seal installer (09231-G2200) (09231-H1100) |
| Installation of the crankshaft rear oil seal A : 09231-G2200 B : 09231-H1100 (Handle) |
| Oil pan remover (09215-3C000) |
| Removal of oil pan |
| Oil filter wrench (09263-2E000) |
| Removal and installation of oil filter |
| Hydraulic tensioner compressor (09244-G2100) |
| Removal and installation of the hydraulic tensioner |
Troubleshooting
Troubleshooting
Symptom
Suspect area
Remedy
Engine misfire with abnormal internal lower engine noises...
Other information:
Hyundai Ioniq (AE) 2017-2025 Service Manual: Oil Pan. Repair procedures
Removal1.Disconnect the battery negative terminal.2.Remove the engine room under cover.(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")3.Drain engine oil.(Refer to Lubrication System - "Engine Oil")4.Remove the oil pan (A).Insert the blade of SST (09215-3C000) between the ladder frame and the oil pan...
Hyundai Ioniq (AE) 2017-2025 Service Manual: Power Door Mirror Assembly. Repair procedures
Inspection1.Disconnect the negative (-) battery terminal.2.Remove the front door quadrant inner cover (A).3.Disconnect the power door mirror connector from the harness.4.Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly...
Categories
- Manuals Home
- 1st Generation Ioniq Owners Manual
- 1st Generation Ioniq Service Manual
- Smart Cruise Control System
- Washer Fluid
- Hybrid battery SOC (State of Charge) gauge
- New on site
- Most important about car
Seat Belt Warning Light
Seat belt warning light
As a reminder to the driver, the seat belt warning light will illuminate and warning chime will sound for approximately 6 seconds each time you place the Engine Start/Stop button to the ON position if the seat belt is unfastened.
Copyright © 2025 www.hioniqae.com