Hyundai Ioniq: Input shaft speed sensor 2 / Specifications
| Specification |
|
Item
|
Specification
|
| Type | Hall effect sensor |
| Operation condition (°C)°F | -40 to 257 °F (-40 to 125 °C ) |
| Output signal (mA) | High: 11.8 - 16.8 |
| Low: 5.9 - 8.4 |
Description and operation
Description•
Components location : DCT (Dual Clutch Transmission)•
Function
The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM)...
Other information:
Hyundai Ioniq (AE) 2017-2025 Service Manual: High Mounted Stop Lamp. Repair procedures
Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear spoiler assembly.(Refer to Body - "Tail Gate Trim")3.Disconnect the high mounted stop lamp connector.4.Remove the high mounted stop lamp cover by pulling forward in the direction of the arrow using screw driver or remover...
Hyundai Ioniq (AE) 2017-2025 Service Manual: Center Pillar Trim. Repair procedures
Replacement[Center pillar lower trim] • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...
Categories
- Manuals Home
- 1st Generation Ioniq Owners Manual
- 1st Generation Ioniq Service Manual
- Checking the Coolant Level
- Tilt Steering / Telescope Steering
- Check brakes/Check regenerative brakes, Check Virtual Engine Sound System
- New on site
- Most important about car
Driver Position Memory System
The Driver Position Memory System is provided to store and recall the following memory settings with a simple button operation.
- Driver's seat position
- Side view mirror position
- Instrument panel illumination intensity
Copyright © 2025 www.hioniqae.com