Hyundai Ioniq (AE): Brake System / ESP(Electronic Stability Program) System
- Components and components location
- Description and operation
- Troubleshooting
- Front Wheel Speed Sensor. Components and components location
- Front Wheel Speed Sensor. Repair procedures
- Rear Wheel Speed Sensor. Components and components location
- Rear Wheel Speed Sensor. Repair procedures
- ESP OFF Switch. Description and operation
- ESP OFF Switch. Components and components location
- ESP OFF Switch. Repair procedures
- Emergency Signal System. Description and operation
Removal1.Turn ignition switch OFF and disconnect the negative (-) battery cable.2.Remove the wiring bracket.3.Remove the brake fluid from the reservoir with a syringe.
Components1. IBAU (Intergrated Brake Actuation Unit)2. Pressure Source Unit (PSU)3. Steering angle snesor4. Front wheel speed sensor5. Rear wheel speed sensor
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Mode Control Actuator. Description and operation
DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Repair procedures
Self Diagnosis1.Self-diagnosis process. • When operating the self-diagnostics, the below fault (self-diagnostics code) will blink at 0.5 seconds interval on the temperature display settings (driver's side only) and the remaining symbols are OFF .
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Engine Clutch System
- Engine Control/Fuel System
- How to Connect Portable Charger (ICCB: In-Cable Control Box)
- New on site
- Most important about car
