| Description |
| • | Side Impact Sensors (SIS), each installed on the center part of the right and left front door modules and the right and left center pillars, detects side impact during collision. |
| • | The SRSCM uses the signals from SIS during side collision to determine whether and when to deploy the side air bag. |
Removal • Removal of the airbag must be performed according to the precautions/ procedures described previously.
Components1. Front Pressure Side Impact Sensor (P-SIS)2. Front Gravity Side Impact Sensor (G-SIS)
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
Replacement1.Remove the battery (-) terminal.2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")3.Remove the heater hose (A) and AEWP hose (B).4.Disconnect the lock pin to remove the heater hose pump connector (A).