Hyundai Ioniq: Rear Seat Belt / Rear Seat Belt Retractor. Repair procedures
•
| When installing the belt, make sure not to damage the retractor. |
|
1. | Remove the rear pillar trim. (Refer to Interior Trim - "Rear Pillar Trim") |
2. | After loosening the mounting bolt, remove the rear seat belt lower anchor (A). Tightening torque : 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft) |

|
3. | After loosening the mounting bolts, remove the rear seat belt retractor (A). 
|
4. | To install, reverse the removal procedure. •
| Replace any damaged clips (or pin-type retainers). |
|
|
Other information:
Replacement[Removal]
•
Put on gloves to prevent hand injuries.
•
Use seat covers to avoid damaging any surfaces.1.Remove the roof side molding.(Refer to Body Side Molding - "Roof Side Molding") 2...
Removal1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the rear wheel and tire (A) from the rear hub. Tightening torque : 107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
•
Be careful not to damage the hub bolts when removing the rear wheel and tire (A)...
Categories
Adjust the steering wheel so it points toward your chest, not toward your face.
Make sure you can see the instrument cluster warning lights and gauges. After adjusting,
push the steering wheel both up and down to be certain it is locked in position.
Always adjust the position of the steering wheel before driving.
WARNING
NEVER adjust the steering wheel while driving. This may cause loss of vehicle
control resulting in an accident.

read more