Hyundai Ioniq (AE): Battery Fuse Box / Repair procedures
| Removal |
|
| 1. | Shut off the high voltage. (Refer to Hybrid Control System - "High Voltage Shut-off Procedures") |
| 2. | Remove the battery pack assembly. (Refer to High Voltage Battery System - "Battery Pack Assembly") |
| 3. | Remove the battery fuse box (B) after releasing the fixing hooks (A).
|
| Installation |
|
| 1. | Install the battery fuse box in the reverse order of removal. |
| 2. | Install the battery pack assembly in the reverse order of removal. (Refer to High Voltage Battery System - "Battery Pack Assembly") |
Circuit Diagram
Removal[High Voltage Battery Front Cover]1.Shut off the high voltage.(Refer to Hybrid Control System - "High Voltage Shut-off Procedures")2.Remove the rear seat cushion.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Description and operation
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Auto Defoging Actuator. Description and operation
DescriptionThe auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor rpm and mod
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- General Information
- DCT(Dual Clutch Transmission) System
- Hybrid Vehicle Engine Compartment
- New on site
- Most important about car
