Hyundai Ioniq (AE): What to do in an emergency
- Hazard Warning Flasher
- In Case of an Emergency While Driving
- If the Vehicle will not Start
- If the 12 Volt Battery is Discharged (Hybrid Vehicle)
- If the 12 Volt Battery is Discharged (Plug-In Hybrid Vehicle)
- If the Engine Overheats
- Tire Pressure Monitoring System (TPMS)
- Check Tire Pressure
- Tire Pressure Monitoring System
- Low Tire Pressure Telltale
- TPMS Malfunction Indicator
- Changing a Tire with TPMS
- If You Have a Flat Tire
- Towing
- If an Accident Occurs
The certification label is located on the driver's door sill at the center pillar and shows the maximum allowable weight of the fully loaded vehicle.
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Smart Cruise Control (SCC) Switch. Repair procedures
Removal1.Disconnect the negative (-) battery terminal.2.Remove the steering wheel assembly.(Refer to Steering System -"Steering Wheel")3.Remove the steering back cover (A).4.Remove the steering remote control connector (A).5.Remove the steering remote control (A), after loosening the screws.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Parking Distance Warning (PDW) ON/OFF Switch. Repair procedures
Removal • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Washer Fluid
- Engine Control/Fuel System
- Theft-alarm System
- New on site
- Most important about car
