Replacement1.Disconnect the connector (A), then remove the wiring mounting clips.2.Disconnect the hood latch release cable (A). 3.Loosen the mounting bolts and remove the hood latch assembly (A).
Adjustment1.Place the car on a flat surface and check whether the body and trunk lid are well-aligned. 2.After loosening the tailgate hinge (A) mounting bolt, adjust the tailgate by moving it up and down or from side to side.
Inspection1.Turn the ignition switch ON.2.Connect the GDS.3.Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.4.The voltage will rise with higher intensive light and reduce with lower intensive light.1. Auto light signal2.
Component Location1. Blower unit assembly Components1. Duct Seal2. Intake duct case3. Air intake door assembly4. Intake door5. Seal6. Intake duct case (A)7. Air filter cover (A)8. Intake actuator9. Air filter cover10. Air filter 11. Blower unit pad12.