Removal and Installation1. Remove the oil level gauge (A).2.Install in the reverse order of removal.
Comoinents1. Air cleaner body2. Air cleaner element3. Air cleaner cover4. Air flow sensor5. Air intake hose6. Air duct hose7. Air duct
Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.
Inspection1.Turn the ignition switch OFF. 2.Disconnect the auto defogging connector. 3.Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.