Hyundai Ioniq (AE): Body (Interior and Exterior) / Crash Pad
- Components and components location
- Cluster Fascia Panel. Components and components location
- Cluster Fascia Panel. Repair procedures
- Crash Pad Lower Panel. Components and components location
- Crash Pad Lower Panel. Repair procedures
- Crash Pad Garnish. Components and components location
- Crash Pad Garnish. Repair procedures
- Steering Column Shroud Panel. Components and components location
- Steering Column Shroud Panel. Repair procedures
- Crash Pad Side Cover. Components and components location
- Crash Pad Side Cover. Repair procedures
- Crash Pad Under Cover. Repair procedures
- Glove Box. Components and components location
- Glove Box. Repair procedures
- Glove Box Upper Cover Assembly. Components and components location
- Glove Box Upper Cover Assembly. Repair procedures
- Main Crash Pad Assembly. Components and components location
- Main Crash Pad Assembly. Repair procedures
- Cowl Cross Bar Assembly. Components and components location
Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Components1. Crash pad assembly2. Crash pad side cover [LH]3. Crash pad side cover [RH]4. Steering column shroud lower panel5. Crash pad lower panel
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Auto Defoging Actuator. Description and operation
DescriptionThe auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor rpm and mod
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Repair procedures
Replacement1.Remove the battery (-) terminal.2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")3.Remove the heater hose (A) and AEWP hose (B).4.Disconnect the lock pin to remove the heater hose pump connector (A).
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Aux. Battery Saver+ (Plug-in hybrid vehicle)
- Jump starting procedure
- Brake Fluid
- New on site
- Most important about car
