Inspection[Motor]1.Turn the ignition switch OFF.2.Disconnect the EEGR valve connector.3.Check that the EEGR valve is stuck by foreign material. 4.Measure resistance between motor 1 and 3 control terminals of the motor.
Components Location[Fuel Tank]1. Fuel tank2. Fuel pump3. Fuel filter4. Fuel pressure regulator5. Canister6. Fuel tank air Filter7. Fuel pressure sensor (FPS)8.
DescriptionThe evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. The evaporator temperature sensor has the Negative Temperature Coefficient (NTC).
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper