Hyundai Ioniq (AE): Hybrid Control System / High Voltage Battery Control System
- Description and operation
- Specifications
- Components and components location
- Troubleshooting
- Schematic diagrams
- BMS ECU. Schematic diagrams
- BMS ECU. Repair procedures
- Safety Plug. Description and operation
- Safety Plug. Specifications
- Safety Plug. Schematic diagrams
- Safety Plug. Repair procedures
- Main Relay. Description and operation
- Main Relay. Specifications
- Main Relay. Schematic diagrams
- Main Relay. Repair procedures
- Pre Charge Relay. Description and operation
- Pre Charge Relay. Specifications
- Pre Charge Relay. Schematic diagrams
- Pre Charge Relay. Repair procedures
- Pre-Charge Resistor. Description and operation
- Pre-Charge Resistor. Specifications
- Pre-Charge Resistor. Schematic diagrams
- Pre-Charge Resistor. Repair procedures
- Battery Current Sensor. Description and operation
- Battery Current Sensor. Specifications
- Battery Current Sensor. Schematic diagrams
- Battery Current Sensor. Repair procedures
- Main Fuse. Description and operation
- Main Fuse. Specifications
- Main Fuse. Schematic diagrams
- Main Fuse. Repair procedures
- Battery Temperature Sensor. Description and operation
- Battery Temperature Sensor. Specifications
- Battery Temperature Sensor. Schematic diagrams
- Battery Temperature Sensor. Repair procedures
Removal[High Voltage Battery Front Cover]1.Shut off the high voltage.(Refer to Hybrid Control System - "High Voltage Shut-off Procedures")2.Remove the rear seat cushion.
DescriptionThe high voltage battery system consists of the BMS ECU (Battery Management System ECU), Power Relay Assembly (PRA), safety plug, battery temperature sensor, and battery ambient sensor.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Description and operation
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Rear Corner Radar Unit. Repair procedures
Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear bumper.(Refer to Body - "Rear Bumper")3.Remove the rear corner radar unit (A) after loosening the mounting nuts. • Take care not to separate the bracket from rear bumper when removing the rear corner radar sensor.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Engine Clutch System
- Suspension System
- If the 12 Volt Battery is Discharged (Hybrid Vehicle)
- New on site
- Most important about car
